Ford F-150 TPMS Reset Button: Find It by Year (2009-2024)

The TPMS reset button on a Ford F150 is typically located beneath the steering wheel, near the driver’s sidekick panel, or on the dashboard. To reset the TPMS, you will need to press and hold the reset button for approximately three seconds.

Tired of that pesky tire pressure warning light? Don’t worry—we’re here to help! Whether your Ford F-150 is fresh off the lot or has seen a few adventures, resetting the TPMS (Tire Pressure Monitoring System) is easier than you think. Follow along, and you’ll have it sorted in minutes!

So, where is the TPMS reset button on a Ford F-150? The honest answer is that most F-150s built after 2017 do not have a dedicated TPMS reset button at all. Instead, you reset the system through the instrument cluster menu or the SYNC touchscreen, or by performing a sensor relearn with a TPMS tool. Only certain older trucks (roughly 2009–2014, and some 2015–2017 models) have a physical button. The table below tells you which method your truck uses before you go hunting for a button that may not exist.

Still, seeing that warning light? We’ve got more tricks up our sleeve! Keep reading to learn alternative reset methods and what to do if the light won’t turn off.

Safety note: The TPMS is a warning system, not a substitute for checking pressure. Driving on underinflated tires raises your risk of a blowout and poor handling, and disabling or ignoring the system can leave you legally non-compliant in states that require a working TPMS. Always set pressures with a gauge to the PSI on your door jamb label before resetting.

It may be necessary to use a pen or a similar tool to reach the button. After three seconds, release the reset button.

Does Your Ford F-150 Have a TPMS Reset Button?

Ford changed the F-150 TPMS reset method several times, so the first step is confirming which system your truck has. Use the year ranges below to skip straight to the right procedure.

F-150 TPMS Reset Button by Model Year (2009–2024)

Model Year	Reset Method	Button?
2009–2014	Physical reset button plus sensor relearn	Yes
2015–2017	Button location varies by trim; some use cluster menu only	Sometimes
2018–2020	Instrument cluster menu (Settings > Driver Assist > Tire Pressure)	No
2021–2024	SYNC 4 touchscreen menu only	No

If your truck does have a button, it is almost always in one of three places: under the steering column on the lower dash panel, on the dash near the headlight switch, or tucked inside the glovebox area on certain trims. It is usually a small round button, sometimes recessed, so a pen or small tool helps. Press and hold it for about three seconds to begin the reset.

Resetting The Tpms

The TPMS reset button on a Ford F150 is typically located beneath the steering wheel, near the driver’s sidekick panel, or on the dashboard. Press and hold the button for about three seconds to reset the TPMS.

Press And Hold The Button For Three Seconds

On trucks with a physical button, the reset is a timed sequence, not just a single press. Switch the ignition to ON (engine off) with all tires inflated to the recommended PSI on the door jamb label, then press and release the brake pedal. Cycle the ignition OFF and back to ON three times, ending in ON. Press and release the brake pedal again, then cycle the ignition OFF, ON, OFF, ON, OFF, then ON. The horn should chirp once and the tire pressure light should flash, confirming you are in reset mode. If nothing happens, you missed a step — switch off and start the sequence again.

Release The Button

Once you are in reset mode, walk to each wheel in this order: left front, right front, right rear, left rear. Hold a TPMS relearn tool against the sidewall next to the valve stem until the horn chirps, then move to the next tire. After the final chirp, cycle the ignition off and back on. The light should stay off. If you do not have a relearn tool, an older magnet tool placed over the valve stem works on many pre-2015 sensors.

Use A Pen Or Tool If Necessary

If the TPMS reset button is difficult to reach with your fingers, you may need to use a pen or a similar tool to press and hold the button. Make sure to apply gentle pressure to avoid damaging the button or any surrounding components.

On 2018 and newer F-150s there is no button to press. Use the steering wheel controls to open Settings in the instrument cluster, then go to Driver Assist > Tire Pressure > Reset. On 2021+ trucks with SYNC 4, tap Settings on the touchscreen, then Vehicle > Tire Pressure Monitoring > Reset, and confirm. Either way, the truck must be parked with the ignition on and tires at the correct pressure.

Relearn Procedure After Tire Rotation or Sensor Swap

Rotating your tires or fitting a new TPMS sensor means the truck no longer knows which sensor sits at which corner, so the light will come on even at correct pressure. You need a relearn, not just a reset. Inflate all four tires to spec, put the truck in TPMS learn mode using the button sequence or cluster menu, then trigger each sensor with a relearn tool in the order left front, right front, right rear, left rear. A new sensor also needs its ID registered, which on most F-150s requires a scan tool or a trip to the dealer.

Regularly resetting the TPMS is important for maintaining optimal tire performance and safety. Remember, proper tire pressure not only improves fuel efficiency but also enhances the overall handling and stability of your Ford F150.

Why the TPMS Light Stays On After Reset

If the light returns, the usual culprits are a tire that is still below the recommended PSI, a sensor battery that has reached the end of its life (typically after many years of service), a sensor that was not triggered during the relearn, or a sensor that failed to register its ID. Check pressures with a gauge first, then repeat the relearn. If one corner refuses to chirp, that sensor is the likely fault and needs replacing.

Frequently Asked Questions Of Where Is The Tpms Reset Button On A Ford F150

Where Is The Tpms Reset Button Located?

On 2009–2014 trucks it is usually under the steering column or near the headlight switch. On 2015–2017 trucks it varies by trim, and some models have no button at all. From 2018 onward there is no button — you reset through the cluster or SYNC menu. Check the year table above before you start looking.

How Do I Reset My F150 Tpms?

First confirm whether your truck has a button using the year table. If it does, run the ignition and brake-pedal sequence to enter reset mode, then trigger each sensor with a relearn tool in the order left front, right front, right rear, left rear. If it does not, use Settings > Driver Assist > Tire Pressure > Reset in the cluster, or the SYNC 4 Vehicle menu on 2021+ trucks.

Where Is The Tpms Reset Button On A Ford?

The TPMS reset button on a Ford is typically located beneath the steering wheel, near the driver’s sidekick panel, or on the dashboard. Press and hold the button for approximately three seconds. You may need a pen or similar tool to reach it.

Release the button after three seconds.

Does a 2015 Ford F-150 have a TPMS reset button?

It depends on the trim. Some 2015–2017 F-150s have a physical button under the steering column or near the headlight switch, while others only offer a cluster menu reset. Check your owner’s manual or look for the button before assuming you have one.

How do I reset the TPMS light after inflating tires?

Inflate to the PSI on the door jamb label, then either press and hold the reset button for three seconds (if fitted) or use Settings > Driver Assist > Tire Pressure > Reset in the cluster. On 2021+ trucks, use the SYNC 4 Vehicle menu. If the light stays on, the sensors likely need a relearn.

Where Is The Tpms Sensor On A Ford F150?

The TPMS sensor on a Ford F150 is typically located beneath the steering wheel, near the driver’s sidekick panel, or on the dashboard. It can be reset by pressing and holding the TPMS reset button for approximately three seconds. Remember to use a pen or similar tool to reach the button if needed.

Conclusion

The TPMS reset button on a Ford F150 can usually be found beneath the steering wheel, near the driver’s sidekick panel, or on the dashboard. Once located, press and hold the button for about three seconds, using a pen or similar tool if necessary.

After three seconds, release the button, and the TPMS system will reset. It’s a quick and easy process to ensure your tire pressure is accurately monitored.